• Context Engine ID—Specify the context engine ID of the ENE from which traps need to be forwarded.
This field is automatically populated if the source of trap is selected. If the source of trap is not specified,
you need to manually enter the context engine ID.
• Target Tag—Specify the tag name. The tag identifies the list of NMS that should receive the forwarded
traps. Traps are forwarded to all GNE Trap destinations whose proxy tags list contains this tag.
• Remote User Details
• User Name—Specify the user name.
• Security Level—Select the security level for the user. The options are noAuthNoPriv, AuthNoPriv,
and AuthPriv.
• Authentication—Select the authentication algorithm.
• Protocol—Select the authentication algorithm you want to use. The options are NONE, MD5, and
SHA. The default is None.
• Password—Enter the password if you select MD5 or SHA.
• Privacy—Enables the host to encrypt the contents of the message that is sent to the agent.
• Protocol—Select NONE, DES, or AES-256-CFB as the privacy authentication algorithm. Encryption
is disabled if NONE is selected.
• Password—Enter the password if you select protocol other than None. The password should not
exceed 64 characters.
Step 5 Click OK to save the information.
Step 6 Return to your originating procedure (NTP).
DLP-G505 Automatically Configuring the SNMPv3 Proxy Trap Forwarder Table
This procedure creates an entry in the SNMPv3 Proxy
Trap Forwarder Table automatically.
Purpose
NoneTools/Equipment
Login to CTC in System Setup and Software
Installation Guide for Cisco NCS 4000 Series.
Prerequisite Procedures
As neededRequired/As Needed
OnsiteOnsite/Remote
Provisioning or higherSecurity Level
Turning Up a Node
76
Turning Up a Node
DLP-G505 Automatically Configuring the SNMPv3 Proxy Trap Forwarder Table
To Next Page
Loading...
