Step 8 On the ENE, complete the DLP-G499 Configure SNMPv3 Trap Destination , on page 70. The target IP
address should be the IP address of the GNE. The UDP port number is 161. Use the user name configured in
Step 6.
Step 9 From the network view, click the Provisioning > SNMPv3 tabs.
Step 10 Complete the DLP-G504 Manually Configuring the SNMPv3 Proxy Trap Forwarder Table, on page 75.
The source of the trap must be the IP address of the ENE. For the field, provide the of the ENE. Also, you
need to specify the target tag defined in Step 4, and the incoming user details configured in Step 6.
Stop. You have completed this procedure.
NTP-G215 Automatically Provisioning a GNE/ENE to Send
SNMPv3 Traps Using SNMPv3
This procedure describes how to automatically
configure the GNE/ENE to allow an ENE to send
SNMPv3 traps to the NMS.
Purpose
NoneTools/Equipment
• DLP-G46 Log into CTC
• NTP-G22 Verifying Common Card Installation
Prerequisite Procedures
Required if you want to implement SNMPv3 on your
network.
Required/As Needed
Onsite or remoteOnsite/Remote
Provisioning or higherSecurity Level
Procedure
Step 1 Go to Network View.
Step 2 Double-click the GNE.
Step 3 Complete the task DLP-G496 Creating an SNMPv3 User, on page 68 to create an SNMPv3 user on the GNE.
Step 4 On the GNE, complete the following tasks:
• DLP-G499 Configure SNMPv3 Trap Destination , on page 70. The target IP address must be the IPv4
or IPv6 address of the NMS. For the UDP Port number, use the port number on which the NMS is listening
for traps. Also, specify a target tag name.
• DLP-G505 Automatically Configuring the SNMPv3 Proxy Trap Forwarder Table, on page 76. Use the
target tag configured in Step 3. Use the IP address of the ENE as the source of trap. The following details
are created automatically:
• A user named ons_trap_user on the ENE
Turning Up a Node
67
Turning Up a Node
NTP-G215 Automatically Provisioning a GNE/ENE to Send SNMPv3 Traps Using SNMPv3
To Next Page
Loading...
