Cisco ONS 15454 - NTP-G355 Provisioning OTDR; DLP-G793 Configuring Common OTDR Parameters for OTDR Scan

Step 8 In the Alien Wavelength pane, complete the following:
• From the Alien Wavelength drop-down list, choose the required wavelength. Select Trunk 100G or 200G
for 100GS-CK-LC and 200G-CK-LC cards.
• From the FEC drop-down list, choose the required FEC type.
Step 9 In the Alien wavelength pane, click Finish.
Step 10 Return to your originating procedure (NTP).
NTP-G355 Provisioning OTDR
This procedure describes how to provision OTDR for
the TNCS-O and TNCS-2O cards.
Purpose
TNCS-O or TNCS-2O cardsTools/Equipment
• DLP-G46 Log into CTCPrerequisite Procedures
As NeededRequired/As Needed
Onsite/RemoteOnsite/Remote
NoneSecurity Level
Procedure
Step 1 Complete the DLP-G793 Configuring Common OTDR Parameters for OTDR Scan, on page 79.
Step 2 Complete the DLP-G782 Configuring OTDR Port Values , on page 81.
Step 3 Complete the DLP-G783 Provisioning OTDR Scan Recurrence, on page 84.
Step 4 Complete the DLP-G784 Configuring Threshold Values for OTDR Scan , on page 85.
Stop. You have completed this procedure.
DLP-G793 Configuring Common OTDR Parameters for OTDR Scan
(Cisco ONS 15454 M6, NCS 2015, ) This task lets
you configure common OTDR parameters for OTDR
scan on TNCS-O and TNCS-2O cards.
Purpose
TNCS-O or TNCS-2O cardTools/Equipment
Turning Up a Node
79
Turning Up a Node
NTP-G355 Provisioning OTDR