NTP-G210 Provisioning Node for SNMPv3
This procedure provisions the node to allow SNMPv3
access.
Purpose
NoneTools/Equipment
• DLP-G46 Log into CTC
• NTP-G22 Verifying Common Card Installation
Prerequisite Procedures
Required if you want to implement SNMPv3 on your
network.
Required/As Needed
Onsite or remoteOnsite/Remote
Provisioning or higherSecurity Level
Procedure
Step 1 In node view, click the Provisioning > SNMP > SNMP V3 tabs.
Step 2 Complete the following tasks as required:
• DLP-G496 Creating an SNMPv3 User, on page 68
• DLP-G498 Create Group Access , on page 69
A group named default_group is defined in the initial configuration. The default group has
read and notify access to the complete MIB tree.
Note
• DLP-G497 Create MIB Views , on page 69
A view named full_view is defined in the initial configuration. It includes the complete MIB
tree supported on the node.
Note
Stop. You have completed this procedure.
NTP-G211 Provisioning Node to Send SNMPv3 Traps
This procedure provisions a node to send SNMP v3
traps.
Purpose
NoneTools/Equipment
• DLP-G46 Log into CTC
• NTP-G22 Verifying Common Card Installation
Prerequisite Procedures
Turning Up a Node
63
Turning Up a Node
NTP-G210 Provisioning Node for SNMPv3
To Next Page
Loading...
