Procedure
Step 1 Go to network view.
Step 2 Double-click the ENE.
Step 3 Click Provisioning > SNMP > SNMP V3 > General and note the context engine ID. The is required in
Step 7.
Step 4 Double-click the GNE.
Step 5 Complete the DLP-G496 Creating an SNMPv3 User, on page 68 to create an SNMPv3 user on the GNE.
Step 6 Complete the following tasks as needed on the ENE:
• DLP-G496 Creating an SNMPv3 User, on page 68
• DLP-G498 Create Group Access , on page 69
• DLP-G497 Create MIB Views , on page 69
Step 7 Complete the DLP-G502 Manually Configuring the SNMPv3 Proxy Forwarder Table, on page 73. Use the
context engine ID from Step 3, the local user details created in Step 5, and the remote user created in Step 6.
Stop. You have completed this procedure.
NTP-G213 Automatically Provisioning a GNE to Manage an ENE
using SNMPv3
This procedure describes how to automatically
configure a GNE to allow an NMS to manage an ENE
using SNMPv3.
Purpose
NoneTools/Equipment
• DLP-G46 Log into CTC
• NTP-G22 Verifying Common Card Installation
Prerequisite Procedures
Required if you want to implement SNMPv3 on your
network.
Required/As Needed
Onsite or remoteOnsite/Remote
Provisioning or higherSecurity Level
Procedure
Step 1 Go to network view.
Step 2 Double-click the GNE.
Turning Up a Node
65
Turning Up a Node
NTP-G213 Automatically Provisioning a GNE to Manage an ENE using SNMPv3
To Next Page
Loading...
