Cisco ONS 15454 - DLP-G501 Creating Notification Filters

As neededRequired/As Needed
OnsiteOnsite/Remote
Provisioning or higherSecurity Level
Procedure
Step 1 In node view, click the Provisioning > SNMP > SNMPv3 > Trap Destination tabs.
Step 2 In the Trap Destinations area, select the trap you want to delete.
Step 3 Click Delete. A confirmation dialog box appears.
Step 4 Click Yes.
Step 5 Return to your originating procedure (NTP).
DLP-G501 Creating Notification Filters
This procedure creates SNMPv3 notification filters.Purpose
NoneTools/Equipment
DLP-G46 Log into CTCPrerequisite Procedures
As neededRequired/As Needed
OnsiteOnsite/Remote
Provisioning or higherSecurity Level
Procedure
Step 1 In node view, click the Provisioning > SNMP > SNMP V3 > Notification Filters tabs.
Step 2 Click Create.
Step 3 In the Create Notify dialog box, enter the following information:
• Filter Profile Name—Specify a name for the filter.
• Subtree OID—The MIB subtree which, when combined with the mask, defines the family of subtrees.
• Bit Mask—A family of view subtrees. Each bit in the bit mask corresponds to a sub-identifier of the
subtree OID.
• View Type—Select the view type. Options are Include and Exclude. Type defines whether the family
of subtrees that are defined by the subtree OID and the bit mask combination are included or excluded
from the notification filter.
Step 4 Click OK to save the information.
Turning Up a Node
72
Turning Up a Node
DLP-G501 Creating Notification Filters