Cisco ONS 15454 - DLP-G541 Adding an ANS Parameter

NoneTools/Equipment
DLP-G46 Log into CTCPrerequisite Procedures
As neededRequired/As Needed
Onsite or remoteOnsite/Remote
Provisioning or higherSecurity Level
It is recommended that you use the Cisco Transport Planner XML configuration file to provision the ANS
parameters instead of manually adding all the parameters in CTC. ANS provisioning parameters must be
manually changed only by Cisco qualified personnel. Provisioning the ANS parameters incorrectly (either as
preamplifier or booster input power thresholds) may impact traffic.
Note
Procedure
As needed, complete the following tasks:
• Complete the DLP-G541 Adding an ANS Parameter, on page 14.
• Complete the DLP-G681 Modifying an ANS Parameter, on page 15.
• Complete the DLP-G542 Deleting an ANS Parameter, on page 17.
Stop. You have completed this procedure.
DLP-G541 Adding an ANS Parameter
This tasks adds an ANS parameter.Purpose
NoneTools/Equipment
DLP-G46 Log into CTCPrerequisite Procedures
As neededRequired/As Needed
Onsite or remoteOnsite/Remote
Provisioning or higherSecurity Level
Procedure
Step 1 In node view (single-shelf mode) or multishelf view (multishelf mode), click the Provisioning > WDM-ANS
> Provisioning tabs.
Turning Up a Node
14
Turning Up a Node
DLP-G541 Adding an ANS Parameter