Cisco ONS 15454 - DLP-G497 Create MIB Views; DLP-G498 Create Group Access

• Password—Enter a password if you select a protocol other than None.
Step 4 Click OK to create an SNMP user.
Step 5 Return to your originating procedure.
DLP-G497 Create MIB Views
This procedure creates an SNMPv3 MIB view.Purpose
NoneTools/Equipment
• DLP-G46 Log into CTCPrerequisite Procedures
As neededRequired/As Needed
OnsiteOnsite/Remote
Provisioning or higherSecurity Level
Procedure
Step 1 In node view, click the Provisioning > SNMP > SNMP V3 > MIB views tabs.
Step 2 Click Create.
Step 3 In the Create Views dialog box, enter the following information:
• Name—Name of the view.
• Subtree OID—The MIB subtree which, when combined with the mask, defines the family of subtrees.
• Bit Mask—A family of view subtrees. Each bit in the bit mask corresponds to a sub-identifier of the
subtree OID.
• Type—Select the view type. Options are Included and Excluded.
Type defines whether the family of subtrees that are defined by the subtree OID and the bit mask
combination are included or excluded from the notification filter.
Step 4 Click OK to save the information.
Step 5 Return to your originating procedure.
DLP-G498 Create Group Access
This procedure creates a user group and configures
the access parameters for the users in the group.
Purpose
Turning Up a Node
69
Turning Up a Node
DLP-G497 Create MIB Views