Procedure
Step 1 In network view, click Provisioning > SNMPv3 tabs.
Step 2 In the SNMPv3 Proxy Server area, complete the following:
• From the GNE drop-down list, choose the GNE to be used as the SNMPv3 proxy server.
• Check the Enable IPv6 Target/Trap check box if the nodes and the NMS stations are on an IPv6
network.
Step 3 In the SNMPv3 Proxy Trap Forwarder Table area, click Auto Create.
Step 4 In the Automatic Configuration of SNMPv3 Proxy Trap Forwarder dialog box, enter the following information:
• Target Tag—Specify the tag name. The tag identifies the list of NMS that should receive the forwarded
traps. All GNE Trap destinations that have this tag in their proxy tags list are chosen.
• Source of Trap—The list of ENEs whose traps are forwarded to the SNMPv3 Trap destinations that are
identified by the Target Tag.
Step 5 Click OK to save the information.
Step 6 Return to your originating procedure.
DLP-G789 Enable RSVP on an Interface
This procedure enables RSVP on an interface for OCH
unnumbered tunnel creation.
Purpose
NoneTools/Equipment
DLP-G46 Log into CTCPrerequisite Procedures
As neededRequired/As Needed
OnsiteOnsite/Remote
Provisioning or higherSecurity Level
Procedure
Step 1 In node view (single-shelf mode) or multishelf view (multishelf mode), click the Provisioning > Networking >
RSVP-TE tabs.
Step 2 Choose the interface from the Interface drop-down list.
Step 3 Click Refresh.
Step 4 In the Card area, double-click the slot that you want to configure.
Step 5 In the Slot drop-down, select the required controller.
Step 6 Click Apply to save the information.
Turning Up a Node
77
Turning Up a Node
DLP-G789 Enable RSVP on an Interface
To Next Page
Loading...
