• To delete optical channels see the DLP-G347 Deleting Optical Channel Client Connections and the
DLP-G106 Deleting Optical Channel Network Connections; to delete overhead circuits, see the DLP-G112
Deleting Overhead Circuits.
• To remove the card as a timing source, see the NTP-G87 Change Node Timing Parameters procedure.
• To remove OSC or GCC terminations, see the NTP-G85 Modify or Delete OSC Terminations, GCC
Terminations, and Provisionable Patchcords procedure.
• To delete LMP channels or links, see NTP-G164 Configure Link Management Protocol.
• To remove a DWDM patchcord, see the DLP-G355 Deleting an Internal Patchcord .
• To remove an optical side, see the DLP-G480 Deleting an Optical Side .
Step 2 On the shelf graphic in CTC, right-click the card that you want to remove and choose Delete Card.
Step 3 Return to your originating procedure (NTP).
DLP-G353 Pre-provisioning a Slot
This task pre-provisions a ONS 15454 slot in CTC.
Pre-provisioning of all the slots in the shelf is
normally performed when you complete the
NTP-G143 Importing the Cisco Transport Planner
NE Update Configuration File procedure. Use this
task if you need to manually pre-provision a slot. All
slot pre-provisioning must be based on the
Cisco Transport Planner shelf layout prepared for your
site.
Purpose
Cisco Transport Planner shelf layout table or JPG file.Tools/Equipment
• NTP-G139 Verifying Cisco Transport Planner
Reports and Files
• DLP-G46 Log into CTC
Prerequisite Procedures
As neededRequired/As Needed
Onsite or remoteOnsite/Remote
Provisioning or higherSecurity Level
Procedure
Step 1 In node view (single-shelf mode) or multishelf view (multishelf mode), right-click an empty slot where you
want to install a card.
Step 2 From the Add Card shortcut menu, choose the card type that will be installed based on the
Cisco Transport Planner shelf layout. Only cards that can be installed in the slot appear in the Add Card
Turning Up a Node
6
Turning Up a Node
DLP-G353 Pre-provisioning a Slot
To Next Page
Loading...
