Cisco ONS 15454 - DLP-G499 Configure SNMPv3 Trap Destination

NoneTools/Equipment
• DLP-G46 Log into CTCPrerequisite Procedures
As neededRequired/As Needed
OnsiteOnsite/Remote
Provisioning or higherSecurity Level
Procedure
Step 1 In node view, click the Provisioning > SNMP > SNMP V3 > Group Access tabs.
Step 2 Click Create.
Step 3 In the Create Group Access dialog box, enter the following information:
• Group Name—The name of the SNMP group, or collection of users, who share a common access policy.
• Security Level—The security level for which the access parameters are defined. Select from the following
options:
• noAuthNoPriv—Uses a user name match for authentication.
• AuthNoPriv—Provides authentication based on the HMAC-MD5 or HMAC-SHA algorithms.
• AuthPriv—Provides authentication based on the HMAC-MD5 or HMAC-SHA algorithms. Provides
DES 56-bit encryption based on the CBC-DES (DES-56) standard, in addition to authentication.
If you select authNoPriv or authPriv for a group, the corresponding user must be configured with
an authentication protocol and password, with privacy protocol and password, or both.
• Views
• Read View Name—Read view name for the group.
• Notify View Name—Notify view name for the group.
• Allow SNMP Sets—Select this check box if you want the SNMP agent to accept SNMP SET requests.
If this check box is not selected, SET requests are rejected.
SNMP SET request access is implemented for very few objects.
Note
Step 4 Click OK to save the information.
Step 5 Return to your originating procedure .
DLP-G499 Configure SNMPv3 Trap Destination
This procedure configures SNMPv3 trap destination.Purpose
NoneTools/Equipment
Turning Up a Node
70
Turning Up a Node
DLP-G499 Configure SNMPv3 Trap Destination