Cisco ONS 15454 - DLP-G681 Modifying an ANS Parameter

Step 2 Click Add. The Add ANS Parameter dialog box appears.
Step 3 Select the ANS parameter from the Parameter drop-down list.
Step 4 In the Port Selection area, complete the following fields:
• Type—Displays the card type.
• Shelf—Choose the shelf from the drop-down list.
• Slot—Choose the card from the Slot drop-down list. The drop-down list lists all the cards that support
the ANS parameter selected in Step 3.
• Port—Choose the port from the Port drop-down list. The drop-down list lists all the ports for the card
selected in Step 4 that support the ANS parameter selected in Step 3.
Step 5 Choose the granularity as OTS or OCH from the Granularity drop-down list.
Granularity can be set only for the ANS parameters applied to the LINE-RX, LINE-TX, COM-RX,
or COM-TX ports.
Note
Step 6 Type or choose the value for the ANS parameter in the Value field.
Step 7 Click OK.
Step 8 Return to your originating procedure (NTP).
DLP-G681 Modifying an ANS Parameter
This task modifies ANS parameters.Purpose
NoneTools/Equipment
DLP-G46 Log into CTCPrerequisite Procedures
As neededRequired/As Needed
Onsite or remoteOnsite/Remote
Provisioning or higherSecurity Level
Do not begin this procedure until the Cisco Transport Planner NE Update file is created for the node. You
must import the new NE Update file and run ANS to recalculate the ANS parameters for the node.
Note
Modifying ANS parameters on one node requires ANS upgrades on all the other nodes within the network.
Do not begin this procedure until you are prepared to complete the upgrade on all the network nodes.
Caution
This procedure will affect the service of unprotected circuits that pass through the node.
Caution
Turning Up a Node
15
Turning Up a Node
DLP-G681 Modifying an ANS Parameter