Step 5 Return to your originating procedure (NTP).
DLP-G502 Manually Configuring the SNMPv3 Proxy Forwarder Table
This procedure creates an entry in the SNMPv3 Proxy
Forwarder Table.
Purpose
NoneTools/Equipment
Login to CTC in System Setup and Software
Installation Guide for Cisco NCS 4000 Series.
Prerequisite Procedures
As neededRequired/As Needed
OnsiteOnsite/Remote
Provisioning or higherSecurity Level
Procedure
Step 1 In network view, click Provisioning > SNMPv3.
Step 2 In the SNMPv3 Proxy Server area, complete the following:
• From the GNE drop-down list, choose the GNE to be used as the SNMPv3 proxy server.
• Check the Enable IPv6 Target/Trap check box if the nodes and the NMS stations are on an IPv6
network.
Step 3 In the SNMPv3 Proxy Forwarder Table area, click Manual Create.
Step 4 In the Manual Configuration of SNMPv3 Proxy Forwarder dialog box, enter the following information:
• Target Address—Target to which the request should be forwarded. Use an IPv4 or an IPv6 address.
• Context Engine ID—The context engine ID of the ENE to which the request is to be forwarded. The
context engine ID should be the same as the context engine ID of the incoming request.
• Proxy Type—Type of SNMP request that needs to be forwarded. The options are Read and Write.
• Local User Details—The details of the local user who proxies on behalf of the ENE user.
• User Name—Specify the name of the user on the host that connects to the agent.
• Local Security Level—Select the security level of the incoming requests that are to be forwarded.
The options are noAuthNoPriv, AuthNoPriv, and AuthPriv.
• Remote User Details— User to which the request is forwarded.
• User Name—Specify the user name of the remote user.
• Remote Security Level—Select the security level of the outgoing requests. The options are
noAuthNoPriv, AuthNoPriv, and AuthPriv.
Turning Up a Node
73
Turning Up a Node
DLP-G502 Manually Configuring the SNMPv3 Proxy Forwarder Table
To Next Page
Loading...
