Cisco ONS 15454 - OpenSSH Version; NTP-G29 Setting Up SNMP

The port number for secure TL1 is 4083. The port number for non-secure TL1 is3083.
EPNM-based interfaces need to be updated with the correct port details for the node.
Use any SSH client on Windows.
Note
Stop. You have completed this procedure.
OpenSSH Version
The OpenSSH version that is currently supported is 3.5.9.1 and will be upgraded in a future release.
The OpenSSH has been upgraded to Cisco SSH Release 1.4.
Note
NTP-G29 Setting Up SNMP
This procedure provisions the SNMP parameters so
that you can use SNMP management software with
the ONS 15454.
Purpose
NoneTools/Equipment
• DLP-G46 Log into CTC
• NTP-G22 Verifying Common Card Installation
Prerequisite Procedures
Required if SNMP is used at your site.Required/As Needed
Onsite or remoteOnsite/Remote
Provisioning or higherSecurity Level
Procedure
Step 1 In node view (single-shelf mode) or multishelf view (multishelf mode), click the Provisioning > SNMP tabs.
Step 2 In the Trap Destinations area, click Create.
Step 3 Complete the following in the Create SNMP Trap Destination dialog box.
• Destination IP Address—Type the IP address of your network management system (NMS). If the node
you are logged into is an ENE, set the destination address to the GNE.
You can configure IPv6 addresses for SNMPv2/v3 trap destinations and SNMPv3 proxy targets,
in addition to IPv4 addresses.
Note
Turning Up a Node
3
Turning Up a Node
OpenSSH Version