• Authentication
• Protocol—Select the authentication algorithm you want to use. The options are None, MD5, and
SHA.
• Password—Enter the password if you select MD5 or SHA.
• Privacy—Enables the host to encrypt the contents of the message that is sent to the agent.
• Protocol—Select NONE ,DES or AES-256-CFB as the privacy authentication algorithm.
• Password—Enter the password if you select protocol other than None. The password should not
exceed 64 characters.
Step 5 Click OK to save the information.
Step 6 Return to your originating procedure.
DLP-G503 Automatically Configuring the SNMPv3 Proxy Forwarder Table
This procedure creates an entry in the SNMPv3 Proxy
Forwarder Table.
Purpose
NoneTools/Equipment
Login to CTC in System Setup and Software
Installation Guide for Cisco NCS 4000 Series.
Prerequisite Procedures
As neededRequired/As Needed
OnsiteOnsite/Remote
Provisioning or higherSecurity Level
Procedure
Step 1 In network view, click Provisioning > SNMPv3 tabs.
Step 2 In the SNMPv3 Proxy Server area, complete the following:
• From the GNE drop-down list, choose the GNE to be used as the SNMPv3 proxy server.
• Select the Enable IPv6 Target/Trap check box if the nodes and the NMS stations are on an IPv6 network.
Step 3 In the SNMPv3 Proxy Forwarder Table area, click Auto Create.
Step 4 In the Automatic Configuration of SNMPv3 Proxy Forwarder dialog box, enter the following information:
• Proxy Type—Select the type of proxies to be forwarded. The options are Read and Write.
• Security Level—Select the security level for the incoming requests that are to be forwarded. The options
are:
Turning Up a Node
74
Turning Up a Node
DLP-G503 Automatically Configuring the SNMPv3 Proxy Forwarder Table
To Next Page
Loading...
