NoneSecurity Level
Procedure
Step 1 Determine which type of node you are fibering.
The following node types require the listed equipment. The cards and patch panels should already be installed
before you begin this procedure.
• Terminal node:
• One of 32DMX-O card and 32MUX-O card, and one standard or deep patch panel tray
• One of 32WSS card and 32DMX or 32DMX-O card, and one standard or deep patch panel tray
• One of 32WSS-L card and 32DMX-L card, and one standard or deep patch panel tray
• One of 40-WSS-C or 40-WSS-CE card and 40-DMX-C or 40-DMX-CE card, and one standard or
deep patch panel tray
• One of 40-MUX-C card and 40-DMX-C or 40-DMX-CE card, and one standard or deep patch panel
tray
• One 40-SMR1-C card and one 15216-MD-40-ODD,15216-EF-40-ODD, or 15216-MD-48-ODD
(15216 40 or 48-channel mux/demux) patch panel
• One 40-SMR2-C card and one 15216-MD-40-ODD,15216-EF-40-ODD, or 15216-MD-48-ODD
(15216 40 or 48-channel mux/demux) patch panel
• One 80-WXC-C card, one 15216-MD-40-ODD, 15216-EF-40-ODD, or 15216-MD-48-ODD unit,
and one 15216-MD-40-EVEN, 15216-EF-40-EVEN, or 15216-MD-48-EVEN unit, and one
15216-MD-ID-50 or 15216-MD-48-CM unit
• One 16-WXC-FS card, one 15216-MD-48-ODD unit, 15216-MD-48-EVEN unit, and one EDRA-2
• Hub node:
• Two of 32MUX-O cards and 32DMX-O or 32DMX cards, and two standard or deep patch panel
trays
• Two of 32WSS cards and 32DMX or 32DMX-O cards, and two standard or deep patch panel trays
• Two of 32WSS-L cards and 32DMX-L cards, and two standard or deep patch panel trays
• Two of 40-WSS-C or 40-WSS-CE cards and 40-DMX-C or 40DMX-CE cards, and two standard
or deep patch panel trays
• Two 40-SMR1-C cards and two 15216-MD-40-ODD, 15216-EF-40-ODD, or 15216-MD-48-ODD
patch panels
• Two 40-SMR2-C cards and two 15216-MD-40-ODD, 15216-EF-40-ODD, or 15216-MD-48-ODD
patch panels
• ROADM node:
Turning Up a Node
32
Turning Up a Node
NTP-G140 Installing Fiber-Optic Cables Between Terminal, Hub, or ROADM Nodes
To Next Page
Loading...
