Cisco UCS C Series Configuration Guide

CHAPTER 9
Configuring Communication Services
This chapter includes the following sections:
• Configuring HTTP, page 47
• Configuring SSH, page 48
• IPMI Over LAN, page 49
• Configuring IPMI over LAN, page 49
Configuring HTTP
Before You Begin
You must log in as a user with admin privileges to configure HTTP.
Procedure
Step 1
In the Navigation pane, click the Admin tab.
Step 2
On the Admin tab, click Communication Services.
Step 3
In the HTTP Properties area, update the following properties:
DescriptionName
Whether HTTP and HTTPS are enabled on the CIMC.HTTP/S Enabled check box
The port to use for HTTP communication. The default is 80.HTTP Port field
The port to use for HTTPS communication. The default is 443HTTPS Port field
The number of seconds to wait between HTTP requests before the CIMC
times out and terminates the session.
Session Timeout field
Enter an integer between 60 and 10,800. The default is 1,800 seconds.
Cisco UCS C-Series Servers Integrated Management Controller GUI Configuration Guide, Release 1.1(2)
OL-22894-01 47

Cisco UCS C Series Specifications

General

Processor	Intel Xeon Scalable Processors
Management	Cisco Integrated Management Controller (CIMC)
Memory	DDR4
Storage	NVMe
RAID Support	Yes
Network	Multiple Gigabit Ethernet and 10 Gigabit Ethernet options
Power Supply	Redundant power supply options
Operating System Support	VMware, Microsoft Windows, Linux
Form Factor	Rack Server