CHAPTER 11
Configuring Platform Event Filters
This chapter includes the following sections:
• Platform Event Filters, page 57
• Enabling Platform Event Alerts, page 57
• Disabling Platform Event Alerts, page 58
• Configuring Platform Event Filters, page 58
• Configuring SNMP Trap Settings, page 59
Platform Event Filters
A platform event filter (PEF) can trigger an action and generate an alert when a critical hardware-related event
occurs. For each PEF, you can choose the action to be taken (or take no action) when a platform event occurs.
You can also choose to generate and send an alert when a platform event occurs. Alerts are sent as an SNMP
trap, so you must configure an SNMP trap destination before the alerts can be sent.
You can globally enable or disable the generation of platform event alerts. When disabled, alerts are not sent
even if PEFs are configured to send them.
Enabling Platform Event Alerts
Before You Begin
You must log in as a user with admin privileges to enable platform event alerts.
Cisco UCS C-Series Servers Integrated Management Controller GUI Configuration Guide, Release 1.1(2)
OL-22894-01 57
To Next Page
Loading...
