Cisco UCS C Series - Clearing the CIMC Log; Sending the CIMC Log to a Remote Server

Clearing the CIMC Log
Before You Begin
You must log in as a user with user privileges to clear the CIMC log.
Procedure
Step 1
In the Navigation pane, click the Admin tab.
Step 2
On the Admin tab, click CIMC Log.
Step 3
In the CIMC Log pane, click Clear Log.
Step 4
In the dialog box that appears, click OK.
Sending the CIMC Log to a Remote Server
You can configure profiles for one or two remote syslog servers to receive CIMC log entries.
Procedure
Step 1
In the Navigation pane, click the Admin tab.
Step 2
On the Admin tab, click CIMC Log.
Step 3
In the CIMC Log pane, click the Remote Logging tab.
Step 4
In either of the Remote Syslog Server dialog boxes, complete the following fields:
DescriptionName
If checked, CIMC sends log messages to the Syslog server named in
the IP Address field.
Enabled check box
The IP address of the Syslog server on which the CIMC log should be
stored.
IP Address field
Step 5
Click Save Changes.
Cisco UCS C-Series Servers Integrated Management Controller GUI Configuration Guide, Release 1.1(2)
66 OL-22894-01
Clearing the CIMC Log
CIMC Log