Removing the Top Cover
The server chassis has a top sheetmetal cover that is secured by two M3xL10.2 mm thumb screws.
Gather a #2 Phillips screwdriver before starting this procedure.
Before you begin
For Recyclers Only! This procedure is not a standard field-service option. This procedure is for recyclers
who will be reclaiming the electronics for proper disposal to comply with local eco design and e-waste
regulations.
Warning
Procedure
Step 1 Using the screwdriver, remove the two thumbscrews.
Figure 52: Location of Thumbscrews
Step 2 Grasp the top cover and slide it forward, then lift up to remove it from the server chassis.
Cisco UCS C885A M8 Server Installation and Service Guide
90
Recycling Server Components
Removing the Top Cover
To Next Page
Loading...
