Removing CNPWR1 and PWR2 Cable
The server has multiple power cables that enable distribution of power cables to different PCBs and components.
Use the following procedure to disconnect the power cable that attaches to connectors CNPWR1 and PWR2.
Before you begin
For Recyclers Only! This procedure is not a standard field-service option. This procedure is for recyclers
who will be reclaiming the electronics for proper disposal to comply with local eco design and e-waste
regulations.
Warning
Procedure
Step 1 Locate the power cable.
Step 2 Disconnect the power cables from the CEM Base Board by using the connector latch.
a) Locate the connector latch.
b) Press down on the latch to open it.
c) While holding the latch open, pull the cable out of the connector.
Figure 63: Detaching the Cable from the Connector
Step 3 After the cable is disconnected, release it from the T1 cable clip.
Cisco UCS C885A M8 Server Installation and Service Guide
104
Recycling Server Components
Removing CNPWR1 and PWR2 Cable
To Next Page
Loading...
