Figure 57: Location of Mini Cool Edge Cables
Step 2 Grasp each cable by the connector that attaches to the HIB board.
Caution
Do not attempt to disconnect the cable from the CEM Module end!
Step 3 Holding the cable connector vertical, pull straight up until it disconnects from the socket on the HIB.
Step 4 Repeat this procedure for each cable.
What to do next
Removing the CEM Base Board, on page 98
Removing the CEM Base Board
The CEM Base Board supports Mini Cool Edge cables that terminate on the CEM Base Board and on the
HIB. If you have not already disconnected the Mini Cool Edge cables from the HIB, do so now.
Caution
Cisco UCS C885A M8 Server Installation and Service Guide
98
Recycling Server Components
Removing the CEM Base Board
To Next Page
Loading...
