Removing the Right CEM Module
The server has multiple CEM Modules which occupy the right and left sides of the server. Right and left are
in relation to the rear of the server.
The CEM on the right side of the server is secured by four (4) M3x L6mm Phillips screws, two screws on the
server's sheetmetal side wall and two on the front faceplate of the server.
Gather a #2 Phillips screwdriver before starting this procedure.
Before you begin
For Recyclers Only! This procedure is not a standard field-service option. This procedure is for recyclers
who will be reclaiming the electronics for proper disposal to comply with local eco design and e-waste
regulations.
Warning
Procedure
Step 1 Using the screwdriver, remove all four M3x L6mm screws.
Step 2 Grasping the CEM Module, lift if straight up out of the server.
Figure 74: Removing the Right CEM Module
What to do next
Removing the SAS Cable, on page 117
Cisco UCS C885A M8 Server Installation and Service Guide
116
Recycling Server Components
Removing the Right CEM Module
To Next Page
Loading...
