Figure 35: Tightening Thumbscrews
Step 9 When the server is installed in the rack and all trays are in place, connect the PSUs to facility power.
The server will power up when the facility power circuit is energized. As part of the server boot up sequence, a power
on self-test (POST) occurs. If an error is encountered, a POST error code is displayed, if available. For more information,
go to POST Error Codes, on page 65.
Initial Server Setup
After rack installation and power on, the server can be assigned an IP address and connected to server
management through the Cisco BMC to enable the server to operate in standalone mode.
Server Default Settings
The server is shipped with these default settings:
• The NIC mode is dedicated.
If you want to use the 1-Gb/10-Gb Ethernet ports on the OCP NIC to access the Cisco Integrated
Management Interface, and enable Shared NIC from the WebGUI after completing Cisco BMC Network
Setting configuration.
• Make sure that the following Network Settings for the Cisco BMC configuration are set.
• Use Domain Name is enabled
Cisco UCS C885A M8 Server Installation and Service Guide
39
Installing the Server
Initial Server Setup
To Next Page
Loading...
