Removing the Air Baffle and Cable Holder
The air baffle and cable holder are a single molded piece that provide optimal airflow and gather and organize
cables that run through the middle of the server. This single part is secured to the server by two (2) M3x
L10.2mm Phillips thumb screws.
Gather a #2 Phillips screwdriver before starting this procedure.
Before you begin
For Recyclers Only! This procedure is not a standard field-service option. This procedure is for recyclers
who will be reclaiming the electronics for proper disposal to comply with local eco design and e-waste
regulations.
Warning
Procedure
Step 1 Locate the M3x L10.2mm thumbscrews.
Cisco UCS C885A M8 Server Installation and Service Guide
129
Recycling Server Components
Removing the Air Baffle and Cable Holder
To Next Page
Loading...
