FastenerIndicator
M3x L5.5mm screws (2)
Red Circle
M3x L11.9mm screws (2)
Yellow Circle
Step 2 Using a screwdriver, remove all screws and disconnect the boards from the server sheetmetal.
Recycling HGBB Module
Use this task to detach the HGBB Tray's PCB for recycling.
The HGBB tray is heavy! Never attempt to lift or maneuver the tray by yourself! Instead, use a lift, scissors
jack, or some other device to lift and bear the weight of the HGBB tray while you are installing or servicing
it. If you must lift or handle the tray without mechanical assistance, use two or more people to lift and handle
server. Always use safe lifting practices when lifting or moving the HGBB tray.
Warning
Before you begin
If you have not already done so, remove power from the server.
For this procedure, gather a #2 Phillips screwdriver.
Procedure
Step 1 Remove the HGBB Tray:
a) Using the screwdriver or your fingers, loosen the two thumbscrews.
b) Pull the tray handle to detach the HGBB Tray from the main chassis assembly.
Cisco UCS C885A M8 Server Installation and Service Guide
136
Recycling Server Components
Recycling HGBB Module
To Next Page
Loading...
