Removing the Mini Cool Edge Cables
The server has a total of sixteen (16) Mini Cool Edge Cables arranged vertically so that half the cables (the
top cables) are installed on top of the other half (the bottom cables). The top row contains eight (8) cables,
and the bottom row contains eight (8) cables.
For the top row of eight cables:
• One end of each cable terminates in a connector that inserts vertically into a socket on the Host Interface
Board (HIB).
• The other end of each cable terminates on the CEM Base Board.
This procedure enables you to remove the top row of Mini Cool Edge cables. For the procedure to remove
the other Mini Cool Edge cables, go to:
• Removing CNCL1 and CNCL2 Mini Cool Edge Cables, on page 107
• Removing CNCR1 and CNCR2 Mini Cool Edge Cable, on page 105
Before you begin
For Recyclers Only! This procedure is not a standard field-service option. This procedure is for recyclers
who will be reclaiming the electronics for proper disposal to comply with local eco design and e-waste
regulations.
Warning
Procedure
Step 1 Locate the top row of eight cables.
Cisco UCS C885A M8 Server Installation and Service Guide
97
Recycling Server Components
Removing the Mini Cool Edge Cables
To Next Page
Loading...
