Figure 48: Replacing the NVMe/SSD in the Carrier Assembly
Step 4 Install NVMe/SAS SSD carrier assembly to the chassis:
a) Place the NVMe/SAS SSD carrier assembly into the chassis.
b) Push the carrier assembly into the chassis until it latches into place.
Figure 49: Replacing the NVMe/SSD Carrier Assembly
Step 5 (Optional) Replace the front bezel.
Removing and Replacing the DC-SCM Module
The DC-SCM Module is part of the CPU Tray below the left CEM Module. The module is a FRU that is
offered in the following options depending on the type of CPU and GPU installed in the server.
Cisco UCS C885A M8 Server Installation and Service Guide
59
Maintaining the Server
Removing and Replacing the DC-SCM Module
To Next Page
Loading...
