Procedure
Grasp the cable holder module and lift it up to remove it.
Figure 71: Removing the Cable Holder Cover
What to do next
Removing the PWR1 and PWR6 Power Cable, on page 113
Removing the PWR1 and PWR6 Power Cable
The server has multiple power cables. Use this procedure to remove the power cable that spans between the
PWR1 and HPM PWR6 connectors.
Before you begin
For Recyclers Only! This procedure is not a standard field-service option. This procedure is for recyclers
who will be reclaiming the electronics for proper disposal to comply with local eco design and e-waste
regulations.
Warning
Cisco UCS C885A M8 Server Installation and Service Guide
113
Recycling Server Components
Removing the PWR1 and PWR6 Power Cable
To Next Page
Loading...
