Removing the SAS Cable
The server has a power cable that provides power to the SAS Interposer card (SAS cable). The SAS cable
connects to the CN1 and C1 connectors. Each end of the cable terminates at a latch connector.
Use the following procedure to disconnect the SAS cable.
Before you begin
For Recyclers Only! This procedure is not a standard field-service option. This procedure is for recyclers
who will be reclaiming the electronics for proper disposal to comply with local eco design and e-waste
regulations.
Warning
Procedure
Step 1 Locate the SAS cable and connectors.
Step 2 Disconnect the power cable from the PSU by using the connector latch.
a) Locate the connector latch.
b) Press down on the latch to open it.
c) While holding the latch open, pull the cable out of the connector.
Cisco UCS C885A M8 Server Installation and Service Guide
117
Recycling Server Components
Removing the SAS Cable
To Next Page
Loading...
