Figure 44: Removing the 54V Redundant PSU
Step 2 Replace the 54V redundant power supply unit:
a) Install the 54V redundant power supply unit:
b) Push the new power supply into the power bay until it locks into place.
Figure 45: Replacing the 54V Redundant PSU
Removing and Replacing the NVMe/SAS SSD Drive
The server supports SAS/NVMe SSDs in the front-loading drive bays below the fan modules.
Before you begin
To perform this procedure, you will need access to the front of the server. If you haven't already removed the
front bezel, do so now.
For this procedure, gather a #2 Phillips screwdriver.
Cisco UCS C885A M8 Server Installation and Service Guide
57
Maintaining the Server
Removing and Replacing the NVMe/SAS SSD Drive
To Next Page
Loading...
