Removing the Air Baffle Module
The air baffle module sits on top of the cable holder covers and spans the width of the server. The module is
secured to the server by eight (8) M3xL6mm Phillips screws on the top of the air baffle module and four
M3xL6mm Phillips screws, two each on the sides of the air baffle module that contact the server's sheetmetal
walls.
Gather a #2 Phillips screwdriver before starting this procedure.
Before you begin
For Recyclers Only! This procedure is not a standard field-service option. This procedure is for recyclers
who will be reclaiming the electronics for proper disposal to comply with local eco design and e-waste
regulations.
Warning
Procedure
Step 1 Using the screwdriver, remove the eight M3xL6mm screws on the top of the module.
Figure 69: Removing the Screws
Step 2 Using the screwdriver, remove the four M3xL6mm screws on the sides of the server.
Step 3 Grasp the air baffle module by the edges and lift it off of the server.
Cisco UCS C885A M8 Server Installation and Service Guide
111
Recycling Server Components
Removing the Air Baffle Module
To Next Page
Loading...
