Before you begin
For Recyclers Only! This procedure is not a standard field-service option. This procedure is for recyclers
who will be reclaiming the electronics for proper disposal to comply with local eco design and e-waste
regulations.
Warning
Procedure
Step 1 Using the screwdriver, remove the eight M3x L6mm screws.
Step 2 Release the T Pins on each side.
Step 3 Slide the HIB module forward then up to lift it off of the server.
Figure 68: Removing the HIB Module
What to do next
Removing the Air Baffle Module, on page 111
Cisco UCS C885A M8 Server Installation and Service Guide
110
Recycling Server Components
Recycling Server Components
To Next Page
Loading...
