Figure 64: Disconnecting the Cable Clip
What to do next
Removing CNCR1 and CNCR2 Mini Cool Edge Cable, on page 105
Removing CNCR1 and CNCR2 Mini Cool Edge Cable
The server has multiple sets of Mini Cool Edge cables.
• Two cables on the bottom row attach to the CNCR1 and CNCR2 connectors.
• One end of each cable connects to the HIB.
• The other end of the cable connects to the CEM.
Use the following procedure to remove the cables.
Cisco UCS C885A M8 Server Installation and Service Guide
105
Recycling Server Components
Removing CNCR1 and CNCR2 Mini Cool Edge Cable
To Next Page
Loading...
