Before you begin
For Recyclers Only! This procedure is not a standard field-service option. This procedure is for recyclers
who will be reclaiming the electronics for proper disposal to comply with local eco design and e-waste
regulations.
Warning
Procedure
Step 1 Grasp each cable by the connector that attaches to the HIB board.
Caution
Do not attempt to disconnect the cable from the CEM Module end!
Step 2 Holding the cable connector vertical, pull straight up until it disconnects from the connector on the HIB.
Figure 65: Disconnecting the Cable Connector
Step 3 Repeat this procedure to disconnect both cables from the HIB
Step 4 When the cables are disconnected from the HIB, release the cables from the T16 and T20 cable clips.
Cisco UCS C885A M8 Server Installation and Service Guide
106
Recycling Server Components
Recycling Server Components
To Next Page
Loading...
