Figure 60: Removing the Power Cable
Step 4 Repeat this procedure for each cable attached to the CEM Base Board.
What to do next
Removing the Main Power Cable, on page 101
Removing the Main Power Cable
The server has multiple different power cables that connect to the rear of each power supply (PSU).
Use the following procedure to remove a power cable.
Before you begin
For Recyclers Only! This procedure is not a standard field-service option. This procedure is for recyclers
who will be reclaiming the electronics for proper disposal to comply with local eco design and e-waste
regulations.
Warning
Procedure
Step 1 Locate the power cable and the power cable connector.
Cisco UCS C885A M8 Server Installation and Service Guide
101
Recycling Server Components
Removing the Main Power Cable
To Next Page
Loading...
