Cisco UCS C885A M8 - Removing CNCL1 and CNCL2 Mini Cool Edge Cables

What to do next
Removing CNCL1 and CNCL2 Mini Cool Edge Cables, on page 107
Removing CNCL1 and CNCL2 Mini Cool Edge Cables
The server has multiple sets of Mini Cool Edge cables.
• Two cables on the bottom row attach to the CNCL1 and CNCL2 connectors.
• One end of each cable connects to the HIB.
• The other end of the cable connects to a CEM.
Use the following procedure to remove the cables.
Before you begin
For Recyclers Only! This procedure is not a standard field-service option. This procedure is for recyclers
who will be reclaiming the electronics for proper disposal to comply with local eco design and e-waste
regulations.
Warning
Procedure
Step 1 Grasp each cable by the connector that attaches to the HIB board.
Caution
Do not attempt to disconnect the cable from the CEM Module end!
Step 2 Holding the cable connector vertical, pull straight up until it disconnects from the connector on the HIB.
Cisco UCS C885A M8 Server Installation and Service Guide
107
Recycling Server Components
Removing CNCL1 and CNCL2 Mini Cool Edge Cables