Cisco UCS C885A M8 - Page 70

PIDDC-SCM Module
C885A-M8-DCSCM(=)UCS C885A M8 DC-SCM Card Module supporting
NVIDIA GPU, 5th Gen AMD EPYC CPU
C885A-M8-DCSCMAA(=)UCS C885A M8 DC-SCM Card Module supporting
AMD GPU, 5th Gen AMD EPYC CPU
C885A-M8-DCSCMGN(=)UCS C885A M8 DCSCM Card Module supporting
NVIDIA GPU, 4th Gen AMD EPYC CPU
Use the following task to replace the DC-SCM Module.
Before you begin
For this procedure, gather a #2 Phillips screwdriver.
Procedure
Step 1 Remove the DC-SCM Module.
a) Using a Phillips screwdriver, loosen the thumbscrew.
b) Grasp the DC-SCM module and slide it out of the CPU Tray.
Figure 50: Removing the DC-SCM Module
Step 2 Install the DC-SCM Module.
a) Align the DC-SCM Module with its slot on the CPU Tray.
b) Holding the module level, slide it into the CPU Tray.
c) When the module is flush with the CPU Tray, use the Phillips screwdriver to tighten the thumbscrews.
Cisco UCS C885A M8 Server Installation and Service Guide
60
Maintaining the Server
Removing and Replacing the DC-SCM Module