The CEM Base board is secured to the server by ten (10) M3xL6mm Phillips screws.
Gather a #2 Phillips screwdriver before starting this procedure.
Before you begin
For Recyclers Only! This procedure is not a standard field-service option. This procedure is for recyclers
who will be reclaiming the electronics for proper disposal to comply with local eco design and e-waste
regulations.
Warning
Procedure
Step 1 Using the screwdriver, remove the M3xL6mm screws.
Figure 58: Location of Screws
Step 2 Grasping the CEM Base Board by its edges, lift it straight up to remove it from the server.
Cisco UCS C885A M8 Server Installation and Service Guide
99
Recycling Server Components
Recycling Server Components
To Next Page
Loading...
