Before you begin
If you have not already done so, remove the CPU Tray's top cover.
You will find it helpful to gather a #2 Phillips screwdriver before attempting this procedure.
Procedure
Step 1 Using a Phillips screwdriver, loosen the two thumbscrews (1) and four screws (2) for the eight CEM baseboards.
Figure 121: Loosening the Thumbscrew and Screws
Step 2 Slide the CEM BB access panel back and up to detach it from the server.
Cisco UCS C885A M8 Server Installation and Service Guide
155
Recycling Server Components
Recycling Server Components
To Next Page
Loading...
