Configuration | User Management
12-3
VPN 3000 Concentrator Series User Guide
Configuration | User Management
This section of the Manager lets you configure base-group, group, and individual user parameters. These
parameters determine access and use of the VPN Concentrator.
Figure 12-1: Configuration | User Management screen
Configuration | User Management | Base Group
This Manager screen lets you configure the default, or base-group, parameters. Base-group parameters
are those that are most likely to be common across all groups and users, and they streamline the
configuration task. Groups can “inherit” parameters from this base group, and users can “inherit”
parameters from their group or the base group. You can override these parameters as you configure
groups and users. Users who are not members of a group are, by default, members of the base group.
On this screen, you configure three kinds of parameters:
•
General Parameters: security, access, performance, and protocols.
• IPSec Parameters: IP Security tunneling protocol.
• PPTP/L2TP Parameters: PPTP and L2TP tunneling protocols.
Before configuring these parameters, you should configure:
• Access Hours (
Configuration | Policy Management | Access Hours).
• Rules and filters (
Configuration | Policy Management | Traffic Management | Rules and Filters).
• IPSec Security Associations (
Configuration | Policy Management | Traffic Management | Security
Associations
).
• Network Lists for filtering and split tunneling (Configuration | Policy Management | Traffic Management |
Network Lists
).
• User Authentication servers, and specifically the internal authentication server (Configuration | System
| Servers | Authentication
).
Using the tabs
This screen includes three tabbed sections. Click each tab to display its parameters. As you move from
tab to tab, the Manager retains your settings. When you have finished setting parameters on all tabbed
sections, click
Apply or Cancel.
To Next Page
Loading...
Need help?
General