13 Policy Management
13-38
VPN 3000 Concentrator Series User Guide
Figure 13-17: Configuration | Policy Management | Traffic Management | Assign Rules to Filter |
Change SA on Rule screen
Change SA on Rule in Filter:
The Manager shows the name of the filter to which the IPSec rule is assigned. You cannot change this
name here. See
Configuration | Policy Management | Traffic Management | Filters | Modify.
IPSec SAs
The IPSec SAs list shows the configured SAs that are available; i.e., all the SAs in the active
configuration. By default, the SA that is currently applied to the rule is selected.
Apply / Cancel
To apply a different SA to this rule, select the SA from the list and click Apply. The Manager returns to
the
Configuration | Policy Management | Traffic Management | Assign Rules to Filter screen for the filter you
are configuring, modifies the active configuration, and updates the
Current Rules in Filter list to show the
rule with its new SA. The change takes effect as soon as you click
Apply. If this filter is being used by an
active interface or group, the change may affect tunnel traffic.
Reminder: To save the active configuration and make it the boot configuration, click the
Save Needed icon at the
top of the Manager window.
To discard the change and keep the current SA on the rule, click
Cancel. The Manager returns to the
Configuration | Policy Management | Traffic Management | Assign Rules to Filter screen for the filter you are
configuring, and the
Current Rules in Filter list is unchanged.
To Next Page
Loading...
Need help?
General