Introduction
Initial Installation
Cisco Small Business WRV210 Administration Guide 14
1
• RADIUS (WEP): Weak security (WEP) with a basic encryption method that
is not as secure as WPA. WEP may be required if your network devices do
not support WPA. Authentication is provided by a RADIUS server that is
connected to the router.
STEP 4 From the Wireless Isolation within SSID drop-down list, choose Enabled to allow
communication and file transfers between all wireless PCs that are connected to
this SSID. This feature is useful when setting up a wireless hotspot location.
Choose Disabled (the default option) to prevent communication and file transfers
between the PCs.
STEP 5 In the final section of the page, enter the required information, based on the
chosen security mode, as described below.
For WPA Enterprise modes and RADIUS (WEP) mode:
• RADIUS Server IP Address: Enter the IP address for the RADIUS server.
• RADIUS Server Port: Enter the port number for the RADIUS server.
For WPA Personal modes and WPA Enterprise modes:
• Encryption: For WPA Personal and WPA Enterprise, choose either TKIP or
AES encryption. The encryption method is chosen automatically for the
other WPA modes.
• Shared Secret: Enter 8-32 characters. The Shared Secret is also known as
a Pre-Shared Key.
- For WPA Personal, this key also must be configured in the wireless clients
who want to connect to the network.
- For WPA Enterprise and RADIUS, this key is shared between the router
and the RADIUS server.