P2544PM | 2022-12 | REV H
3 Before Initial Operation
3.1 Requirements
To set up the controller, the following items are required:
• Laptop/PC
• Ethernet cable
• Software S168691 mProRemote Professional
• Software S168688 LiveWire Utilities
• Monitor with VGA connector, keyboard and mouse (optional)
• Micro B USB cable
3.2 Install Software
1. Download the mProRemote Professional and LiveWire Utilities Software from the follow-
ing website: http://software.apextoolgroup.com/current-software-packages/pc-software/
2. Install the mProRemote Professional software on the PC, see Document S168691 mProRe-
mote Professional.
3. Install the S168688 LiveWire Utilities on the PC, see Document P2372JH.
4. Install the tool driver.
5. Set network settings from laptop/PC to i. e. 192.168.100.201 (if mPro200GC-AP is used).
3.3 Install driver
To be able to configure the tool via the PC software, the tool driver must be installed.
Install tool driver
1. Download the tool driver cellcore-celltek-usb-driver.zip from the following website and un-
pack it: https://software.apextoolgroup.com/current-software-packages/celltek/
2. Connect the tool to the PC via a Micro B USB cable.
The tool switches on automatically.
3. Open the device manager on the laptop/PC.
To Next Page
Loading...
