Cleco CellTek S169263 - Menus and Functions; General Functions; Switching on the Tool; Switching off Tool

Menus And Functions
20
P2544PM | 2022-12 | REV H
Apex Tool Group
5
EN
5 Menus And Functions
5.1 General Functions
All paths are specified starting from the main menu.
► To go from the runscreen to the main menu, press the key.
5.1.1 Switching On The Tool
► To switch on the tool, press the start trigger.
5.1.2 Switching Off Tool
There are several ways to switch off the tool.
Option 1:
► Remove the battery.
 Tool switches off after 20 seconds.
Option 2:
1. Select > .
2. Press the button.
 The symbol is displayed on the LCD.
 After five seconds, the tool switches off.
Option 3:
The tool will switch off if it is not used for a certain time, see chapter 5.8.4 Setting the shut-off properties,
page 36.
5.1.3 Selecting a button
When talking about pressing a button in this manual, this means the following:
1. Use the arrow buttons to navigate to the desired button (outlined in blue).
2. Press the button.
5.1.4 Changing parameters
Enter the parameter by changing each character of the value individually. Each character can have a maxi-
mum value of nine.
1. Press the button.
 The value is highlighted in red and an arrow is displayed below the first digit. This digit can be
changed.
2. Change the selected digit using the arrow buttons.
3. Confirm with the button.
 The next digit can be changed.
4. Repeat the procedure with each digit of the value.
5. After the last digit confirm the input with the button to save the input.