P2544PM | 2022-12 | REV H
Torque encoder offset error
Rundown terminated by interruption of the start signal
Max. number of cycles for stick-slip exceeded
Too many stick-slip edges
Canceled by exceeding the max. time
Time that may lapse after threshold torque maximum. If this time is ex-
ceeded, there is a shut-off with this error message.
Time that must pass in the Shut-Off Value after threshold torque minimum is
reached. If the time is less, this error message is output.
Error messages of the gyroscope
Invalid angle value re-
turned from gyroscope.
► Contact a Sales & Service Center, see reverse.
Tool rotated more than
±180°.
► Don‘t rotate tool not more than ±180°.
Tool moved too fast, angle
rate too high.
► Move the tool slower while tightening.
Internal communication er-
ror
► Check gyroscope contact. If error occurs again
contact Sales & Service Center, see reverse.
Supply voltage too high or
too low
Sales & Service Center
Error messages, software updates and data storage
Export script not available.
► Try to export the script two to three times.
► If the error message continues to occur, perform a
► Insert SD card.
► Check SD card for errors.
Error while writing the ar-
chive.
► Check SD card for errors.
Software update script not
available.
► Try two to three times to perform the software up-
date
► If the error message continues to occur, contact a
Sales & Service Center, see reverse
Crash during software up-
date.
Timeout on startup expired.
No compatible update
packages found.
► Make sure there is the right *.tma file selected.
Several *.tma files availa-
ble.
► Select only one *.tma file.
No compatible update
packages found.
► Make sure there is the right *.tma file selected.
To Next Page
Loading...
