Climax FF6300 - Controls; Pneumatic Conditioning Unit Controls; Hydraulic Power Unit Controls

P/N 80679, Rev. 10 Page 21
2.3 CONTROLS
This section explains control locations and functions.
2.3.1 Pneumatic conditioning unit controls
Figure 2-7 shows the controls on the pneumatic-powered version of the FF6300.
FIGURE 2-7. DETAIL OF PNEUMATIC CONDITIONING UNIT CONTROLS
1. START (system reset)—Resets the low-pressure drop-out.
2. Emergency STOP—Isolates the supply air and vents the downstream air. Press
down to stop the machine; pull up to reset.
3. Lock-out/Tag-out valve—Isolates air pressure from the machine and provides
the ability to lock the valve closed so that you can perform maintenance.
4. Air regulator—Controls the air pressure supplied to the machine. The regulator
is preset at the factory, and does not require adjustment.
5. Oiler adjustment—Controls the air lubricator drip rate. For more information,
see Section 5.3.1 on page 64.
6. Feed on/off valve—Turns the feed on or off. This valve has a vent port that
stops the feed immediately when the valve is closed.
7. Speed adjustment valve—Controls the machine’s rate of rotation.
2.3.2 Hydraulic power unit controls
Figure 2-8 on page 22 shows the controls on the hydraulic version of the FF6300.
1 2
4
5
6
7
3