Copyright © 2014 congatec AG IGX1m02 12/134
1 Safety Instructions
Do not connect or disconnect any cables or modules to or from any onboard connectors (except for the rear I/O connectors) until the conga-IGX
is completely powered down.
Any damage caused to the conga-IGX by misuse of the onboard connectors is excluded from the standard warranty. congatec cannot be held
liable for any damage that results from incorrect use of any onboard connectors.
The system integrator is fully responsible for the usage of the appropriate connectors and cables in order to fulll the technical requirements
(electrical contact, durability, power/current levels, signal integrity etc.)
Heatsink Backplate
Caution
Insulating foil of backplate must NOT be removed, otherwise conga-IGX may be damaged due to a possible short circuit.
To Next Page
Loading...