Congatec conga-IGX - Display Options; Basic Display Features; Display Configuration Notes

To Next Page

To Previous Page

5 Display Options

5.1 Basic Display Features

The graphics engine of the conga-IGX supports maximum 2 independent displays, following combinations are possible:

Cong# DisplayPort V1.2

Maximum 3840 x 2160

LVDS

Maximum 1920 x 1200

DVI-I (digital)

Maximum 1920 x 1200

DVI-I (analog VGA)

Maximum 1920 x 1200

1 X X

2 X X (see note below)

3 X X

4 X X (see note below)

Note

Via DVI-I to VGA converter

Simultaneous use of DisplayPort and onboard LVDS is not possible; the appropriate G-series video channel can only be used exclusively for

DisplayPort (=LVDS disabled in BIOS Setup) or for LVDS (=LVDS enabled in BIOS Setup).

The DisplayPort output can be converted to a HDMI output, VGA output or (second) DVI output (appropriate converter required).

Windows 8 mode (=Secure Boot enabled) & LVDS support should only be used for BIOS revision R1.1.0, otherwise any graphics output may

be disabled. In case this happens, Setup Defaults should be enabled (see section Miscellaneous - BIOS/CMOS Reset).