CONQUEST 90 - Introduction

INTRODUCTION
•
Because of its compact 34" size, it High efficiency furnaces require
are always striving to make our
As gas furnace manufacturers we
extends the installation locations for
special attention to the venting
products as efficient, reliable and
system. Only listed venting systems
cost effective as possible. With the
the contractor. It fits into small
closets, low basements, and through may be used as stated in the
advent of current efficiency tight attic access openings making it installation instructions. Installing
minimums, the 60% and 70% a very desirable product to sell and contractors should know that the
furnaces of the past are no longer install. This furnace accepts all our
PVC venting material used with the
allowed on the market. This is for the cooling evaporator coils and 90 Plus furnace has been used for
benefit of all concerned: the installing accessories. years with previous 90 Plus
contractor, the Distributor and the
furnaces. They have the confidence
The 90 Plus furnace is the product of
homeowner. Everyone benefits from
of knowing how the venting system
extensive research, design and field
selling, installing and owning a
works and the experience from
testing. Many of the components in
furnace that gives the customer installing similar systems.
this furnace have been used on the
energy efficiency, longevity and
current Low Profile furnace. This lets However since furnace technology
comfort.
customers know that they are getting and venting requirements do change,
The 90 Plus furnace addresses all of a furnace that will give them years of awareness of local, state, and
those needs. Its new tubular primary reliable service. federal codes, as well as industry
heat exchanger and secondary changes is imperative. Proper
The installing contractor will
condensing heat exchanger give it
application and maintenance are a
recognize familiar components.
an Annual Fuel Utilization Efficiency, must if consumers are to receive all
The igniter, flame sensor, certain
or AFUE, above 90%. Better than the furnace's benefits.
controls, gas valve, and other
90% of the heat generated at the
components have proved to be
A Recognize this symbol as an
burners actually goes into the house.
extremely reliable on previous units indication of important safety
Less than 10% is lost out the vent
and will give similar performance on information.
system. Of every one dollar of heat
this furnace. The installing contractor
purchased more than 90 cents goes
will get almost as much comfort from
into the home.
seeing familiar and reliable parts as
the homeowner realizes from the
warm home he has.
This is a
Category IV furnace. Since
it condenses products of combustion,
its vent temperature is below the flue
products' dew point. It also uses a
pressurized venting system.
F
•
4